Kramer Electronics 610T - Manual (Page 7)

610T, 610R - Using the Detachable Optical DVI System 5
4 Using the Detachable Optical DVI System
This section describes how to:

Capture the EDID of the display device (see Section
4.1
)

Connect the detachable optical DVI transmitter and receiver (see Section 4.2 )

Troubleshooting the 610T and 610R ((see Section 4.3 )
4.1 Capturing the EDID
The 610T and 610R are connected via four channels that transmit R, G, B and
clock signals. The EDID of the display device is captured onto the transmitter for
the computer to read.
You can capture the EDID of the display device on the 610T so that when the
computer connects to the 610T, it will read the virtual EDID information and
identify the display device. This procedure is performed only once for the
connected display device. After storing the EDID, the system can be connected
and disconnected without having to set the EDID again. If the display device is
replaced, the new EDID should be set on the 610T transmitter.
To capture the EDID of a display device, do the following:
1. Connect the 5V power adapter to the power socket of the 610T, and connect
the adapter to the mains electricity.
The Indication LED lights.
2. Push the Auto EDID button (illustrated in Figure 2 ), using a thin screwdriver.
3. Connect the 610T unit directly to the display device.
The Indication LED flashes several times while reading the EDID.
4. When the Indication LED stops flashing, disconnect the power.
5. Disconnect the 610T.
The EDID information is now stored and the Indication LED is on.