WeatherTech License Plate Frames - Manual

License Plate Frame Mounting Instructions
TOOLS NEEDED • #2 Phillips Head Screwdriver • 7/16" Wrench
HELP!
If you have questions regarding installation of this or any
other WeatherTech
® product, please call our customer service
department at (630) 769-1500, Monday through Friday, 9 a.m.
to 5 p.m. Central Time. We want to help you get the most out
of your new WeatherTech
® product.
PLEASE CHECK STATE AND LOCAL LAWS PRIOR TO USE.
High Quality Stainless Steel
Universal Fastener Kit*
Acura, AM General, Audi, BMW, Buick,
Cadillac, Chevrolet, Chrysler, GMC,
Daewoo, Dodge (except Viper), Ferrari,
Ford, Honda, Hummer, Hyundai, Isuzu,
Infiniti, Jaguar, Jeep, Kia, Land Rover,
Lexus, Lincoln, Mazda, Mercedes-
Benz ® , Mitsubishi, Nissan, Oldsmobile,
Pontiac, Porsche ® , Range Rover, Saab,
Saturn, Scion, Subaru, Suzuki, Toyota,
Volkswagen, Volvo
FITS THESE MODELS AND MORE:
CARE INSTRUCTIONS:
• Clean with soapy water or window cleaner
• Do not use abrasive pads, harsh detergents
or degreasers on the ClearFrame™
Specialist In Original Equipment and
Aftermarket Automotive Accessories
CONTENTS:
• ClearFrame™ License Plate Cover
• Stainless Steel Universal Fastener Kit
• Click and Stay
™ Screw Caps
ClearFrame ™
1. Remove the Click and Stay ™ screw caps from the
mounting holes in the WeatherTech ® ClearFrame ™ by
pushing them out from the back side.
2. Lay the WeatherTech ® ClearFrame ™ face down on a
soft or non-abrasive surface.
3. Position the license plate face down into the
protective gasket that is molded into the edge of your
ClearFrame ™ , noting that the ClearFrame ™ gasket
is marked “BOTTOM” for proper positioning. Make
certain that you have a proper fit and seal between the
license plate and the ClearFrame ™ .
4. Select the four mounting screws that are most
appropriate for your vehicle (If your mounting location
only uses 2 holes, then see step 4A FIRST). Carefully
position your ClearFrame ™ license plate assembly into
place on your vehicle and using a #2 Phillips Head
Screwdriver, securely fasten with the screws you have
chosen, BEING CAREFUL NOT TO OVER-TIGHTEN.
(4A) If the mounting location on your vehicle only
uses two screws, then first select machine screws
and matching nuts from the hardware pack. Install
these two screws through the ClearFrame ™ license
plate assembly in the holes that DO NOT go to the
mounting holes on the vehicle. Using a #2 Phillips
Head screwdriver and a wrench, tighten the two nuts
onto the end of each screw, locking the assembly
together, BEING CAREFUL NOT TO OVER-TIGHTEN.
5) Finally, position the Click and Stay ™ screw caps over
each screw on your ClearFrame ™ with the drain hole
on the bottom and push firmly to snap each one into
place.
* Some vehicle
models may require
re-use of existing
fasteners
For joining cover
& plate without
mounting holes
Proudly Designed,
Engineered, and
Manufactured
in the USA.
© 2014 by MacNeil IP LLC