WIKA IPT-11 - Manual (Page 12)

5 .2 General functions
IPT-1* pressure transmitters have various functions. Hence they can
be adapted to the respective application.
Some of these functions are sensor-specific. These are described in
the operating instructions manual of the corresponding sensor. Other
functions, however, have a general character, i.e. they are available in
different sensors.
The general functions are described in this paragraph. The functions of
the indicating/adjustment module are determined by the sensor and
correspond to the respective software version of the sensor.
The following presentations are available in the measured value
display:
l Level or pressure as digital value, sensor-TAG
l Level or pressure as digital value and bar graph, sensor TAG
l Level or pressure as digital value, temperature value
With [->] you select the different presentations of the measured value.
You can reach the menu overview from any presentation with [OK].
With [ESC] you return from the menu overview to the measured value
display.
In the menu overview you select the appropriate menu with [->] and
open it with [OK]. Then the individual menu items are available.
▶ Basic adjustment
Display
Diagnostics
Service
Info
Menu section, basic adjustment
To damp process-dependent measured value fluctuations, you have to
set an integration time of 0 … 999 s in this menu item.
Depending on the sensor type, the factory setting is 0 s or 1 s.
Damping
0 s
In this menu item you select the linearization curve:
l linear
l Cylindrical tank
l Spherical tank
l User programmable
User programmable means: Switching on a linearization curve
programmed via PC and PACTware
Introduction
Measured value indica-
tion
Menu overview
Damping
Linearisation curve
12 Indicating and adjustment module for IPT-1* sensors
5 Set up
31549
-EN
-081211