RADWAG ZRi02 power supplier - Manual (Page 8)

EXI-02-03-06-14-GB - 8 -
• remove the burnt
• mount a new fuse, characterized by parameters given below
• Put on the insulation coating on the fuse (pos.3)
• Screw bolts in the Power supply casing
PCB – fuses placement
1 – B1 : fuse of the primary winding
2 – B2 : fuse of the secondary winding
3 – insulation coating
Specification of fuses:
Miniature CERAMIC fuses 5x20, rated breaking capacity - 1500A AC
compliant with EN 60127-2/5
B1 – T100mA/250V
B2 – T100mA/250V
IT IS FORBIDDEN TO USE FUSES OF OTHER TYPES AND OTHER
PARAMETERS THAN GIVEN IN THIS MANUAL.
USING FUSES OF OTHER TYPES CAN CAUSE LOOSING THE
INTRINSIC SAFETY OF THE OUTPUT CIRCUIT.