American Aimers V100 Photometric Headlight Aimer - Manual (Page 8)

✺
AIMER ALIGNMENT TO LAMP
STEP 1: Position Aimer
Carefully move the aimer ( left to right on
the track only ) in front of one of the lamps
without changing the alignment of the
aimer head completed in Step two.
Vision 100
STEP 2:
With the aimer ON and with the headlamps
ON and at low beam, press the “Align to
Lamp” button. This function is used to
locate the optical center of the lamp.
STEP 3: Find Optical Center
●
To find the optical center of the lamp,
with cover plate closed, place the aimer
in front of headlamp until arrows appear
NOTE: “Lamp to Dim” or “Double X’s” can
appear when aligning aimer to lamp when
aimer is too far off optical center of the lamp.
●
When arrows are displayed they
indicate the direction that the aimer
head needs to be moved either to the
left or right on the track... or up and
down on the mast.
STEP 4:
When both X’s are displayed both axis
are aligned correctly and you have
properly located the center of the lamp.
Turn locking handle clockwise to lock
aimer head in place gently.
Align:
Lamp too dim
Align:
Align: X X
POSITION AIMER
IN FRONT OF LAMP
( LEFT TO RIGHT -
ON TRACK ONLY ).
TURN
HEADLAMPS ON...
WHILE LOOKING AT THE
DIGITAL DISPLAY, MOVE
THE AIMER LEFT OR RIGHT
ON THE TRACK IN THE
DIRECTION OF THE
HORIZONTAL ARROW ...
● It is important to NOT ROTATE the aimer
head during the aiming process as this
would change the aimer-to-vehicle alignment
already completed.
WHILE LOOKING AT THE DIGITAL
DISPLAY, RAISE OR LOWER THE
AIMER HEAD IN THE DIRECTION
OF THE VERTICAL ARROW...
FIG. 1
FIG. 2
FIG. 3
Page 8