EasyN F2 Series User manual - Manual (Page 10)

MF2E-E-A4
- 10 -
4.4. CONNECT NETWORK VIA ROUTER
5. SOFTWARE OPERATION
5.1. IPcamera TOOL
In picture 3, camera-1’s IP is not in the same subnet with computer-1, it can not
be accessed, to run Devfind.exe in CD, click search button then
click-on searched IP Camera, then we can configure the settings, inte rface as
picture 4.
Picture 4- LAN configuration interface
1) Connect device to LAN through cable
2) Configure device through IPcam tool.
(Details refer to: 5.1 IPcamera tool )
3) Access device as administrator.
4) Access ddns setting page to enable DDNS
service then click <set> to restart device.
(Details refer to: 5.6 ddns settings )
5) Then it can be accessed through internet.