Hogtunes REV 200-AA : 2 Channel Class D Amplifier / 2x100 watts (1998 - 2013 - model years) - Manual (Page 6)

6
Step #2: Earlier in the install, you located the black 4 pin plug with the
blue/black and brown/black wires on it and plugged it into the
“amplified output” on the amp. The blue/black wires will plug directly
to the speaker on the brake side of the bike. The brown/black wires will
plug directly to the speaker on the clutch side of the bike. Please double
check that this harness is plugged into the BLACK plug on the amp and
not the blue 4 pin plug on the input harness
Step #3: The orange wire is the “remote turn on lead” and tells the amp to turn on
whenever it sees +12v (.5 amp min.). Unplug the factory center wire (+)
on the cigarette lighter. Plug the orange lead from the amplifier directly
onto the lighter using the female connector. Plug the factory lighter wire
to the male “take off” connector which is part of the amps orange turn
on lead. IMPORTANT: If you do not attach the orange wire from the
amp to the center wire at the cigarette lighter, the amplifier will not turn
on. If the factory fuse for your cigarette lighter is blown and your
cigarette lighter does not work, your amplifier will not turn on.
Step #4: Routing the power harness - For Standards, Street Glide, EG
Classic, and Ultra Classic
For 98-06 bikes, the power harness will pass under the inner fairing
where the throttle and idle cables pass through on the brake side of the
bike. The harness is designed to be routed between the frame backbone
and gas tank on the brake side of the bike and come out just behind the
gas tank. You MAY need to undo the back bolt of the gas tank and pivot
the tank up to allow the harness to pass through at the back of the gas
tank. Be sure to re-install this bolt and torque to factory specs! For 2007-
2013 bikes, the balance of the main wire harness will pass under the
inner fairing where the main wire harness passes through on the brake
side of the bike. Loosen the tank console and run wires up and over the
gas tank, but under the tank console. There is a provision on the front of
the tank console for wires to pass. Secure the amplifiers harness to the
bike’s factory harness using zip ties. When correctly installed, the power
and ground wires are the right length to connect onto the battery.