Hogtunes NCA 450U KIT-AA : 4 Channel Amp / Speakers (1998 - 2013 - model years) - Manual (Page 2)

Thank you for choosing the Hogtunes ® NCA 450U KIT-AA. Since
positive word of mouth is the best way to grow our business, we want
your new system to work as well as it was designed to. If you have
any questions or concerns, we are here to help.
Email: [email protected]
Tel: 705-719-6361
If you still need help, please consider a professional installation
by your motorcycle dealer.
Important: the nCa 450-aa amplifier can not be used
if any factory amplifier is already on the bike. please
call us if you have any questions! We will most likely
have a simple solution for you!
getting started
Step #1: Remove the seat and both wires (+ and —) from the battery.
Step #2: Remove the outer fairing/headlamp assembly. Refer to a service manual
if you need help with this. Note: Placing a towel on the front fender can
help prevent scratches or “dings” from dropped tools or fasteners etc.
Step #3: Take the 2 wires off each front speaker by gently pulling one at a time.
Undo the screws that attach each speaker/grill assembly to the inner
fairing and remove. Gently pull the stock speaker out of each grill
assembly.
Step #4: “Clip” the Hogtunes front speakers (Model 352F-AA) into each grill
assembly. Position your new speaker/grill assembly onto the inner
fairing and re-attach each one using the OE screws. Although a hand
screwdriver is recommended for this step, make sure these screws are
tight! Let the factory speaker wires hang for now.
Step #5: Remove each rear speaker grill by undoing the 4 screws on the front of
the grills. Carefully lift up on each speaker and take the 2 wires off by
pulling one at a time from the stock speaker. Put the grills, fasteners and
speakers aside.
2