Hogtunes REV 200SG Kit-RM : 2 Channel Amp / Speakers (2014 - model year) - Manual (Page 7)

5
Step #4: Figure 1.2
shown here.
Step #5: Also in Fig 1.2 is a white square which shows a smaller black 2 pin fac-
tory plug. The orange wire from the amp has a plug that goes directly
into this factory harness. On the factory plug we are describing, there
may be a factory plug with no wires already installed into it which will
have to be removed. The factory wire colors going into the plug are
purple/blue stripe and black and can be seen under the factory sheath-
ing. The orange wire is the amplifier’s “turn on” lead and tells the amp
to turn on/off with the bikes ignition. The amplifier will not turn on if this
wire is not hooked up to this (or any) switched B+ source!
Step #6: From the amp, take the 2 pin plug with the blue/black wires and install
it into the plug going into the brake side speaker cabinet. Take the 2 pin
plug with the brown/black wires and install it into the plug going into
the clutch side speaker cabinet.
Step #7: From the amp’s input connector, take the 2 pin plug with the green/
black wires an install it into the mating plug on the brake side of the
bike. Also from amp’s input connector, take the 2 pin plug with the
yellow/black wires and install it into the mating plug on the clutch side
of the bike. NOTE: These are the plugs that were originally undone to
allow the speaker cabinet to come out. The plugs will only fit together
one way but, to be absolutely sure, if you look behind the factory wire’s
sheathing, the factory wires are pink and pink/black stripe.
Figure 1.2 - Amplifier and mounting plate
correctly oriented. The plate with four small
holes is for mounting a popular Harley
accessory. The white circles show tabs which
are there for the “Christmas Tree” fasteners to
re-secure the harnesses lifted earlier.