iRobot Scooba 200 Series - Manual (Page 8)

irobot Scooba 200 Series Owner’s Manual 8
Cleaning System
Scooba has an automatic three-part cleaning system that:
1 Washes – Scooba lays down fresh cleaning solution.
2 Scrubs – Scooba gently scrubs the floor.
3 Dries – Scooba uses a squeegee and
vacuum to pick up the dirty water.
Scooba uses only clean water and solution while
washing your floor. The dirty water is stored in a separate tank and is never reused.
Scooba has two cleaning cycles.
Always completely fill Scooba for best performance. Upon completion of a short cycle, Scooba will
have water remaining in the Fill tank and can complete a second short cycle if desired. Be sure to
empty and rinse both tanks before storing for future use.
CauTIOn:
• Do NOT use bleach, ammonia or alcohol in Scooba. These liquids may damage the robot and will void the warranty.
• Do NOT use hot water as it may damage the robot.
• Scooba contains electronic parts. Do NOT submerge Scooba in water. Clean with a damp cloth only.
• Do not use Scooba on unfinished or unsealed wood or laminate flooring, which can be damaged by wet
cleaning methods.
• Always consult your floor manufacturer for approved cleaning methods.
Cleaning Cycle Room Size Approx. Cycle Time How to Start When should I use this cycle?
Full Up to 150 sq. ft. 45 minutes Press Power On
Press Clean and release
when song starts
For larger rooms or any room
that needs extra cleaning time
Short Up to 60 sq. ft. 20 minutes Press Power On
Press and hold Clean
until second song starts
To clean multiple small areas on
a single battery charge
1
3
2