iRobot Verro 300 - Manual (Page 31)

iRobot
®
Ver ro
™
model 300
QUICK START GUIDE
An easy step-by-step guide to using the
iRobot Ver ro Pool Cleaning robot
iRobot
®
Verro
™
model 300 Quick Start Guide
© 2007 iRobot Corporation, 63 South Avenue, Burlington, MA 01803. All rights reserved. iRobot is a registered trademark and Verro is a trademark
of iRobot Corporation. Cover photo © Veer incorporated 2002 - 2005. All rights reserved.
3002.07
Quick Start
(cont...)
See Owner’s Manual
for detailed product
instructions.
Visit
www.irobot.com/usetips
for instructional photos
8 After approximately two hours, Verro will stop and the Power Supply light will
turn off. To stop Verro before the end of the cleaning cycle, switch the Power
Supply OFF.
9
Wait 20 minutes before removing Verro from the pool to allow the pump motor
to cool. Shut off and unplug the Power Supply every time you remove the
cleaner from the water. Always remember to turn the Power Supply OFF and
unplug it from the power outlet before removing the cleaner from the pool.
10
Unplug the Power Supply from the GFCI outlet. Never leave the Power Supply
plugged in when Verro is not in use.
11
Unplug the fl oating power cord from the Power Supply.
12
Use the fl oating power cord to pull Verro to the edge of the pool, then use the
handle to lift it out of the water. Water will drain from Verro as it is lifted.
CAUTION: Removing Verro by its fl oating power cord may cause severe damage
to the cord requiring costly repairs.
13
Store Verro and its Power Supply in a dry area out of direct sunlight. The Power
Supply is water resistant, but not waterproof, and may be damaged by rain.