Verifying user id and password, Pac-i – KMW Communications PAC-I User Manual
Page 16
KMW Communications
5.2 Verifying User ID and password
In order to prevent unauthorized use of PAC and to track/manage user data, all users must go
through the user verification process.
1.
Check to make sure that ANT Port(F) on PAC is
connected to DC Input Port(F) on Bias-T with
SMA(M)-to-SMA(M) Control Cable.
2.
Turn on the power switch at the bottom of PAC-I.
PAC-I
TM
VER:1.1.2.01
3.
Select USER ID by using left (◀) or right (▶)
‘Shift’ key, then pressing ‘ENT’.
User can register up to 10 USER ID’s using both
PAC-I and PAC PC Application.
4.
Type in four-digit password.
Note: If the inputted password is correct, the
next screen will appear automatically. If the
password is incorrect, it will flash “Retry..!”
then ask for the password again.
PASSWORD
01/01 00:00
****
5.
If the correct password is entered and the user is
verified, the MENU screen will appear.
MENU
01/01 00:00
[1] Setup
[2] Antenna Control
[3] Measurement VSWR
[4] Memory Clear
Page 15 of 34
Portable Antenna Controller
KC-50-0001-03
User’s
Guide
10/17/05