MSI B75A-G43 - Manual (Page 48)

2-8
BIOS Setup
Parallel(LPT) Port
Ths tem allows you to enable/ dsable the parallel port.
Parallel(LPT) Port Settngs
Select an address and correspondng nterrupt for the parallel port.
Devce Mode
Select a devce mode for the parallel port.
Hardware Montor
Press <Enter> to enter the sub-menu.
CPU Smart Fan Target
Controls CPU fan speed automatcally dependng on the current temperature and
to keep t wth a specfic range. If the current CPU temperature reaches the target
value, the smart fan functon wll be actvated.
SYS Fan1 Control
These tems allow users to select how percentage of speed for the SYSFAN1.
CPU/ System Temperature, CPU FAN/ SYS FAN 1 Speed
These tems show the current status of all of the montored hardware devces/ com-
ponents such as CPU temperature/ system temperature and the few fans’ speeds.
Power Management Setup
Press <Enter> to enter the sub-menu.
EuP 2013
Energy Usng Products Lot 6 2013 (EUP) reduces power consumpton when system
s off or n standby mode.
Note: When enabled, the system wll not support RTC wake up event functons.
Restore after AC Power Loss
Ths tem specfies whether your system wll reboot after a power falure or nterrupt
occurs. Settngs are:
[Power Off] Always leaves the computer n the power off state.
[Power On] Always leaves the computer n the power on state.
[Last State] Restore the system to the status before power falure or nterrupt
occurred.
Wake Up Event Setup
Press <Enter> to enter the sub-menu.
Wake Up Event By
Settng to [BIOS] actvates the followng fields, and use the followng fields to set the
wake up events. Settng to [OS], the wake up events wll be defined by OS.
Resume By RTC Alarm
The field s used to enable or dsable the feature of bootng up the system on a
scheduled tme/date.
Date/ HH:MM:SS
If Resume By RTC Alarm s set to [Enabled], the system wll automatcally resume
(boot up) on a specfic date/hour/mnute/second specfied n these fields (usng the
<+> and <-> to select the date & tme settngs).
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶