MSI X58 Pro-E - Manual (Page 27)

En-17
Important
Please do not fold the Seral ATA cable nto 90-degree angle. Otherwse, data loss
may occur durng transmsson.
Please always use the Intel default SATA connectors (SATA1~6) first.
Front Panel Connector: JFP1, JFP2
Ths connector s for electrcal connecton to the front panel swtches and LEDs. The
JFP1 s complant wth Intel ® Front Panel I/O Connectvty Desgn Gude.
1.+
3.-
10.N
o Pin
5.-
Rese
t Sw
itch
HDD
LED
Pow
er Sw
itch
Pow
er LE
D
7.+
9.Re
serve
d
8.-
6.+
4.-
2.+
JFP1
1.Gro
und
3.Su
spen
d LE
D
5.Po
wer L
ED
7.No
Pin
8.+
6.-
4.+
2.-
Buzz
er Spea
ker
JFP2
Fan Power Connectors: CPUFAN1, SYSFAN1~3
The fan power connectors support system coolng fan wth +12V. When connectng the
wre to the connectors, always note that the red wre s the postve and should be con-
nected to the +12V; the black wre s Ground and should be connected to GND. If the
manboard has a System Hardware Montor chpset on-board, you must use a specally
desgned fan wth speed sensor to take advantage of the CPU fan control.
1.Gro
und
2.+1
2V
3.Se
nsor
4.Co
ntrol
1.Gro
und
2.+1
2V
3.Se
nsor
1.Gro
und
2.+1
2V
3.No
Use
CPUFAN1 SYSFAN1/2 SYSFAN3
Important
Please refer to the recommended CPU fans at processor’s offical webste or consult
the vendors for proper CPU coolng fan.
CPUFAN1 supports fan control. You can nstall Overclockng Center utlty that wll
automatcally control the CPU fan speed accordng to the actual CPU temperature.
Fan cooler set wth 3 or 4 pns power connector are both avalable for CPUFAN1.
SYSFAN1 and SYSFAN2 support fan control, too. You may select how percentage of
speed for the SYSFAN1/2 n BIOS.
•
•
•
•
•
•