MSI Wind Board User Manual
Page 26
Advertising
2-13
Hardware Setup
Fan Power Connectors: SYS_FAN1/ SYS_FAN2
The fan power connectors support system cooling fan with +12V. When connecting
the wire to the connectors, always note that the red wire is the positive and should
be connected to the +12V; the black wire is Ground and should be connected to GND.
SYS_FAN2
SENSOR
+1 2V
GND
SYS_FAN1
Serial ATA Connector: SATA1~2
This connector is a high-speed Serial ATA interface port. Each connector can connect
to one Serial ATA device.
SATA2
SATA1
Important
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise,
data loss may occur during transmission.
S
E
N
S
O
R
+
1
2
V
G
N
D
PDF created with pdfFactory Pro trial versi
Advertising