MSI NF725GM-P31 - Manual (Page 20)

20
uSB power Jumper: JuSB_PW, JuSB_PW2
these jumpers are used to select uSB ports powered by VCC5 or 5VSB. Set to
5VSB if you want them provide power in standby mode.
JuSB_PW
keep uSB
power to VCC5
(default)
keep uSB
power to 5VSB
(for rear uSB
2.0 ports)
1 1 1
JuSB_PW2
keep uSB
power to VCC5
(default)
keep uSB
power to 5VSB
(for on-board
uSB connec-
tors)
1 1 1
iMPoRtant
if you set the jumper to 5VSB, the power supply must be able to provide at least
2a currents.
Lan, Front audio euP Jumper: JLan_PW, Jaud_PW
euP(energy-using Products) is a standard for reducing power consumption in
standby mode. these jumpers are used to enable/ disable the euP function of the
Lan jack and the front audio connector.
1 1 1
JLan_PW
enable euP
(default)
disable euP
(for Lan jack)
1 1 1
Jaud_PW
(for Jaud
connector) enable euP
(default)
disable euP
iMPoRtant
if you set the jumper to euP, the Wake-on-Lan function will be disabled under
S, S4, S5 state.