Vitek VT-4036 BN - Manual (Page 7)

3. NO SOUND IS COMING FROM THE FRONT RIGHT
SPEAKER
(1) Make sure the front right speaker is properly connected
to the device.
(2) Make sure the device is properly connected to the audio
source.
4. NO SOUND IS COMING FROM THE CENTRAL SPEAKER
(1) Make sure the central speaker is properly connected to
the device.
(2) Make sure the device is properly connected to the audio
source.
(3) Increase the volume of the central speaker.
5. NO SOUND IS COMING FROM THE REAR SPEAKERS
(1) Maker sure the rear speakers are connected properly.
(2) Make sure the device is properly connected to the audio
source.
NOTE: The central and rear speakers only work if the system
is connected to a six channel audio source (for example, a
DVD player with an AC 3/Dolby Digital decoder) or, if in 3D
mode, when connected through the 2.1 CH audio input.
6. NO RADIO STATION RECEPTION
(1) Verify that the antennas are connected to their respective
jacks on the rear panel.
(2) In the FM band – make sure that the FM antenna is fully
extended.
(3) In the AM band – rotate the AM antenna for better signal
reception.
PRECAUTIONARY MEASURES:
Attention: Please carefully read the points listed below to
ensure safe use of the device.
1. Read the instructions The safety instructions and oper
ating rules should be read before using the device.
2. Save the instructions Save the instructions for future
use.
3. Follow the operating rules All of the safety instructions
should be followed.
4. Warning symbols Heed the indications of all warning
symbols located on the device's panels or in these
instructions.
5. Power source The device should only be connected to
a power source with the characteristics indicated on the
rear panel of the device or in these instructions.
6. Protecting the power cord The power cord should be
laid out in such a way that it will not be damaged by
external items or its surroundings.
7. Water and moisture Do not use the device near reser
voirs of water (for example, bath tubs, sinks, etc).
8. Ventilation Install the device in a well ventilated room.
Do not install the device on couches, beds or carpets
because the device's ventilation may be blocked.
9. The effects of heat Do not install the device near heat
sources (for example, radiators, kitchen stoves, etc).
10. Periods of non use if the device will not be used for a
long period of time, disconnect the power plug from the
electrical outlet.
11. The need for maintenance Utilize the services of quali
fied technicians if:
• The power cord is damaged; or
• The device body is damaged; or
• The device was subjected to rain; or
• The device is not functioning properly; or
• The device was subjected to shock.
12. Repair service The consumer should not attempt to
repair the device himself. Use only the services of a qual
ified technician.
13. Clean the device with a dry, soft clothe only.
14. Turn off the device during thunderstorms or when not in
use for a long period of time.
APPENDIX
When connecting the device to a DVD player with a built in
DD/DTS decoder, verify the following:
1. When connected through the 5.1 CH. audio inputs, the 5.1
CH audio output should be chosen in the player's set
tings. Playback discs with AC 3/Dolby Digital 5.1 CH
audio tracks.
2. To turn on the subwoofer, make sure that the speaker size
in the player’s settings for the front, central and rear
speakers is “Small” and that the subwoofer output is set
to “On.”
When connecting the device to DVD player, carefully read
the operating instructions for the DVD player.
ENGLISH
7
4026.qxd 04.10.2005 11:31 Page 7