Nostalgia Electrics TPM100 REDBLK - Manual (Page 8)

E
N
G
LI
S
H
6
HOW TO OPERATE
Before first use, clean the Bucket and Measuring Cap by removing Measuring
Cap from Bucket and wiping both with a moist, non-abrasive sponge,
towel or cloth and then wipe with a non-abrasive dry towel.
Remove the Stirring Rod from the Base by turning Center Knob counterclockwise. Wipe
the Stirring Rod and Base with a moist, non-abrasive sponge, towel or cloth and then
wipe with a non-abrasive dry towel. Replace the Stirring Rod and make sure the rod fits
into the notched area around the screw. Secure by turning Center Knob clockwise.
1. First, find a flat surface near an electrical outlet before starting. Make sure your cord
is away from any water source. It is acceptable to use an extension cord if needed.
2. Gather your popcorn making supplies: popcorn, seasonings, cooking oil, and
measuring spoon for oil. (Kernel Measuring Cap is included with your unit).
3. Measure 3 tablespoons of oil and add to the nonstick Base (oil may also be
added through ventilation slots while corn kernels are popping.
4. Using the Kernel Measuring Cap supplied with your THEATER STYLE
MOTORIZED STIRRING POPCORN MAKER add 6 ounces of corn kernels.
DO NOT exceed the MAX FILL line on the Kernel Measuring Cup.
5. For every Measuring Cap full of kernels (6 oz.), add 3 tablespoons of
oil. For best results, light vegetable oil is recommended.
6. Always remove Kernel Measuring Cap while kernels are popping.
7. Plug in the appliance while switch is flipped to OFF position.
8. Turn appliance ON by flipping the switch on the Base. In no
time at all, you will hear the popping begin.
9. Once popping stops, turn unit OFF, then unplug.
10. Secure Kernel Measuring Cap to Bucket.
11. While wearing oven mitts, flip the Bucket over, remove Base and you
will have hot, fresh and delicious popcorn ready to serve!
Stirring Rod
Base