Helpful tips, Cleaning & maintenance, En g li s h – Nostalgia Electrics MSB600 SERIES User Manual
Page 10
E
N
G
LI
S
H
8
HELPFUL TIPS
UNIT IS NOT TURNING ON
•
If the unit is not turning on, make sure that it is fully and properly plugged into the outlet.
•
Blending Chamber must be firmly attached to Base or unit will not turn on.
BEVERAGE IS NOT DISPENSING
•
Add more liquid to Blending Chamber if vacuum occurs around shaving cage during use.
•
If the beverage is not dispensing, make sure that the Grinding Cage did not get loose.
•
Make sure that there is enough liquid left inside.
•
Make sure that switch is flipped up to the ON position.
•
Make sure that there aren't any ice chips stuck inside the Spout. Open and close
the valve by pushing down on the Spout Handle once or twice quickly.
CLEANING & MAINTENANCE
1.
After using your MARGARATOR PLUS, disconnect from electrical
outlet. Remove plug by gripping the plug body and pulling out of
the outlet. Never yank or twist cord to unplug the unit.
2.
Dispense all remaining liquid from the Blending Chamber.
3.
Remove Blending Chamber from Base and fill Blending Chamber with clean
water. Dispense all of the water through the Spout until liquid runs clear.
4.
Wipe inside and outside of Blending Chamber with a wet, non-abrasive
cloth or sponge and dry thoroughly with a soft, non-abrasive towel.
5.
Wipe Base with a dry, non-abrasive cloth.
6.
DO NOT submerge Blending Chamber or Base in water. When
needed, use a damp, non-abrasive cloth to wipe exterior.
7.
DO NOT put any parts in the dishwasher.
8.
Once washing and drying is complete, reassemble your MARGARATOR
PLUS. Wind the cord and return to the convenient storage location in the
bottom of the Base. Now your MARGARATOR PLUS is ready to use again.
9.
To prolong the life of your MARGARATOR PLUS, be sure to follow the
cleaning instructions after every use and make sure that the Spout is
flushed thoroughly while washing the unit to prevent build up.
10. You may need to occasionally remove and clean the Grinding Cage. Refer to
the directions in the Parts & Assembly section to perform this function.