Nostalgia Electrics RRF300SDD SERIES - Manual (Page 14)

E
N
G
LI
S
H
12
DEFROSTING
Heavy frost will effect the efficiency and performance of the refrigerator and can
create increased energy consumption. If the frost inside of the freezer gets as thick as
¼ inch, you must defrost the refrigerator. Follow these steps to defrost the freezer:
1. Remove all food from the refrigerator and freezer.
2. Uninstall the drawers and shelves.
3. Unplug the power supply cord.
4. Open the doors and wait for the appliance to thaw completely.
5. Clean up the water with dry towels.
NOTE: DO NOT use any other equipment or method to force
the defrost process. It may ruin the cooling system.
DISCONNECTING THE APPLIANCE
After a power failure the refrigerator can keep food cool
for several hours if doors are kept shut.
If the power fails, do not put additional food into the refrigerator or open the doors.
If you plan to have your power shut off for an extended period of time, make
sure to remove all perishable food from the refrigerator or freezer first.
If you stop use of your refrigerator for an extended period
of time, unplug the appliance from the outlet.
Always wait at least five minutes after unplugging the
power supply cord before plugging it back in.
CLEANING & MAINTENANCE
To prolong the life of your Compact Refrigerator with Dispenser, please follow
these simple instructions for maintenance. This appliance should be maintained
and cleaned frequently. For your safety, pull plug from socket before cleaning.
• Interior Maintenance
Clean the interior of the appliance with clean, soapy water.
Wipe dry with a non-abrasive cloth or towel.
• Outer Maintenance
Wipe outside of refrigerator with a dry, non-abrasive cloth or towel.
• Door Gasket
It is easy to damage the door gaskets with oil, sauce, etc. Be very careful when cleaning.
• Beverage Tank
Clean the beverage tank by first draining liquids through the dispenser. Drain remaining
liquids by disconnecting the tap-adapting tube and the door bar drainage hole via
the connecting pipe. Remove beverage tank, then clean interior and exterior of
tank, tube and pipe with warm, soapy water. Rinse thoroughly, wipe dry with a non-
abrasive cloth or towel, and return to unit per the instructions on the previous page.