Sioux Chief Push-Tite Flange Extension - Manual

Push-Tite
TM
Flange Extension
ITEMS NEEDED:
1. Pipe saw, tape measure, screws, screwdriver, primer, glue
2. Push-Tite Gasketed Closet Flange (887-GPM, 887-GAM)
3. 3" Sch. 40 ABS/PVC pipe
Step 1
Cut the hub of the Push-Tite, approximately 1¼"
up from the bottom lip of the hub.
This application is perfect for situations where a closet flange
needs to be added, and the 4" drain pipe is well below the finished floor.
Step 2
Measure the distance from the top of the drain pipe to the
top edge of the finished floor (this distance is X), then add
2" to this measurement.
Step 3
Cut a piece of 3" Sch. 40 pipe (X+2" long). Glue this piece
of pipe between the top and bottom halves of the Push-Tite
closet flange.
Step 4
Lubricate the gasket (use bowl wax, silicone, stem grease,
liquid soap, etc.) and push the pipe/flange assembly down
into the 4" drain pipe.
Step 5
Secure the flange to the floor with screws and
proceed with standard closet installation.
Exclusive
Feature!
SDv1-6/03 PUSH-TITE FLANGE EXTENSION © 2003 SIOUX CHIEF MFG.