TotalPond MF750UV - Manual (Page 4)

4
5. Lift the pump and filter assembly up from the fountain. NOTE: In order
to extract the filter assembly from the flotation basket, the main power
cord must be fed up through the bottom of the flotation basket. Fig. 8
Fig. 8
6. Remove the filter pad and rinse until it is clean. Then reassemble the
pump and filter assembly. Fig. 9
Fig. 9
CARE AND MAINTENANCE
•
General
●
A visible drop in waterflow or increased algae in the pond is your indication that filter
pad, pump, and/or UV clarifier portion of the unit require cleaning.
●
Before attempting to disassemble the Pond Boss™ or clean the pump, UV clarifier or
any portion of the unit, always disconnect the unit from the power source.
●
Disassemble the unit in accordance with the Disassembly Procedure section of this
instruction sheet.
•
Cleaning the Pump
●
Insure the pump is disconnected from all other components comprising the unit.
●
Inspect the pump by removing the front screen and impeller assembly and clean parts
of the pump and clean in warm, soapy water.
●
Reassemble the pump and reposition and connect the low voltage power cables.
Fig. 10