TotalPond UW16257 - Manual (Page 3)

3
4. Connect the light to the sensor by pushing the plug into the
sensor socket until it is firmly seated. Hand tighten the nut
from the plug to the socket. Fig. 4
Fig. 4
5. Connect the sensor to the transformer by pushing the plug
into the transformer socket until it is firmly seated. Hand
tighten the nut from the plug to the socket. Fig. 5
Fig. 5
6. Plug the transformer into a properly grounded electrical outlet.
Fig. 6
Fig. 6
7. The last light in the set has a plug that can used to connect
another set of lights. Additional light sets can be purchased
by calling 1-888-412-6001. Fig. 7
Fig. 7
TROUBLESHOOTING
•
If light fails to illuminate, check that it is getting power by testing another appliance in the same
power outlet.
•
The light is designed to turn on when it gets dark, and turn off when it gets light. To activate the
light during daylight hours, cover the sensor.
•
If light does not turn off during daytime, check sensor. Make sure the sensor faces up and is not
covered by dirt or debris.
CARE AND MAINTENANCE
•
Periodically, your light may require cleaning for optimal performance.
•
Cleaning should only be done with warm soapy water. Be sure to use biodegradable soap.
•
The frequency of cleaning depends upon the conditions of the environment where the light is used.
GFCI
Transformer
Plug from
sensor
Socket from sensor
Plug from light
Plug