Audiovox PRO 9445FT - Manual

REMOTE KEYLESS ENTRY
PRE-INSTALLATION NOTES:
DIP SWITCHES :
This unit incorporates three on - board dip switches for selection of optional features. They are;
ON OFF
Dip Switch #1 Auto Lock/Unlock No Auto Lock/Unlock
Dip Switch #2 Passive Lock Active Locks
Dip Switch #3 Passive Starter Inhibit Active Starter Inhibit
STARTERDISABLE:
This system provides a transistorized output to control the starter cut feature.
When the starter cut relay is installed, any time the doors are remotely locked, the vehicle's starting circuit is disabled.
Additionally, when the passive starter cut feature is selected (dip switch #3 On), then 30 seconds after leaving the vehicle,
the vehicle's starting circuit will be automatically disabled.
CHANNEL 2 OUTPUT:
This system provides an additional hardwire remote output to control an assortment of optional upgrades. This output
is an independent channel from the transmitter, and is controlled by the (Option) button of the transmitter. It is a delayed
ground pulse (300 mA maximum), and can be used to control;
Optional Trunk Release Relay AS-9256
Optional Remote Starter AS-9151N / AS-9075
Optional Window Roll Up AS-9153
Optional Garage Door AS-9154
Additionally, if both transmitter buttons are designated, the remote transmitter has the capability of transmitting a third
RF signal that can be used to operate a second vehicle equipped with a similar Pursuit alarm. By simultaneously
pressing both the "Lock/Unlock" button along with the "Option" button, a third function can be operated.
DOOR LOCK / UNLOCK OUTPUTS:
This system provides both (+) and (-) pulsed door lock outputs for direct connection to most OEM factory installed door
lock control relays. These outputs have a maximum current capability of 300 mA, and external relays must be used for
switching circuits requiring more than 300 mA, and with 4 or 5 wire polarity reversal door lock control circuits. The optional
AS-9159 Door Lock Interface is available to simplify the wiring of these types of circuits.
INSTALLATION OF MAJOR COMPONENTS:
CONTROLMODULE:
Select a mounting location inside the passenger compartment ( up behind the dash ), and secure it using screws,
or cable ties.
DO NOT mount the control module in the engine compartment, as it is not waterproof.
DO NOT mount the unit or route the wiring near the steering shaft, as it might become entangled, preventing proper
operation of the vehicle.
Model PRO 9445FT
Installation Manual
1