Vogels PFF 7810 - Manual (Page 4)

Level Level
In/Out In/Out
Tilt Tilt
Now that you have your first lower center
display attached to the frame, the beauty of
the three part alignment features of the
mounting bracket come into play. The fact that
all the adjustments are on top will make the
final adjusting effortless.
With your Vogel's spirit level in hand, first place
the level on top of the display bezel to set side to
side level. Next, place the level on the face of the
display to adjust top to bottom level of the
display parallel to the frame. Once you have these
steps confirmed, make sure the mounted display
is center on the video wall frame left to right and
tighten the security screws to secure the display
to the round wall frames to further prevent side
to side movement.
Next, follow the same steps for the lower left and
right displays.
Once all three display are aligned and secured,
the final fine adjustment of tilt and in/out can be
used to insure all bezel edges are closely aligned.
This will take a few adjustments back and forth to
determine final screen adjustment.
With the lower two or three display properly
aligned you can move up to the second row,
following the same procedure as the first row.
It is important that the time be taken to maximize
the first row alignment before moving up as you
do not want to have to go back and forth
between rows. If done correctly your bezel edges
should match very closely top and bottom.
Step 6
4
www.vogels.com