Vollrath 60 Qt Countertop Mixers - Manual (Page 5)

5
ENGLISH
O
peratOr
’
s
M
anual
o
Perating the
20 q
uart and
30 q
uart
m
ixers
.
F
A
E
B
C
D
G
Figure 6. 20 Quart and 30 Quart Mixer Control Panel.
A
ON/OFF BUTTON. Switches the mixer on and off.
B
DIGITAL DISPLAY. Displays the time remaining in timed
operation cycle, displays “ON” when operating in an non-timed
cycle and displays “OFF” equipment is plugged in and not
operating.
C
TIME UP BUTTON. Increases the time. Maximum time of 30
minutes.
D
TIME DOWN BUTTON. Decreases the time.
E
STOP BUTTON. Press the switch in to stop the mixer. Rotate
the switch in the clockwise direction to reset.
F
SPEED SELECT LEVER. Used to change the mixer speed.
G
INDICATOR LIGHTS. Illuminates when the mixer in operating
or time has been programmed.
NOTE:
Turn the mixer off before switching from one speed to another. Failure to stop
the mixer before changing speeds may damage the gearbox and void the
warranty.
1. Close the bowl guard (G). See Figure 2. The safety guard must be
closed for the mixer to operate. If the safety guard is open or not closed
properly then the mixer will not operate.
2. Select the desired operating speed based on the ingredients. Use the
speed select lever (F) to set the speed. See Figure 6.
„ Speed 1 – Use for mixing heavy dough with an absorption ratio of 50%
or less.
„ Speed 2 – Use for mixing cakes, batters or heavy dough with an
absorption ratio of more than 50%.
„ Speed 3 – Used for mixing egg whites.
NOTE:
The moisture content of heavy dough is critical when selecting the
proper mixing speed. Do not use speed 2 when mixing heavy dough
with an absorption ratio of 50% or less.
3. Once the speed has been selected, press the on/off button to start the
mixer. Or, select a time by pressing the time up button (D) or time down
button (C). Press the on/off button.
4. To change speeds, press the red button to stop the mixer. Once the
mixing attachment has stopped rotating then change the speed using the
speed control knob. Once the new desired speed has been selected then
press the on/off button to reactivate the mixer.
5. The mixer will stop and the timer will beep three times after the time
cycle has ended.
NOTE:
Turn the mixer off before switching from one speed to another. Failure
to stop the mixer before changing speeds may damage the gearbox
and void the warranty.
o
Perating the
40 q
uart and
60 q
uart
m
ixers
.
E
B
A
C
G
D
F
Figure 7. 40 Quart Mixer Control Panel.
E
B
A
C
G
D
F
Figure 8. 60 Quart Mixer Control Panel.
A
ON BUTTON. Switches the mixer on.
B
DIGITAL DISPLAY. Displays the time remaining in timed
operation cycle, displays “ON” when operating in an non timed
cycle and displays “OFF” equipment is plugged in and not
operating.
C
TIME UP BUTTON. Increases the time. Maximum time of 30
minutes.
D
TIME DOWN BUTTON. Decreases the time.
E
STOP BUTTON. Press the switch in to stop the mixer. Rotate
the switch in the clockwise direction to reset.
F
SPEED SELECT LEVER. Used to change the mixer speed.
G
STOP BUTTON. Switches the mixer off.
NOTE:
Turn the mixer off before switching from one speed to another. Failure
to stop the mixer before changing speeds may damage the gearbox
and void the warranty.