Vollrath MIN0022 Operator Manual User Manual
Page 4
F
ood
P
reParation
e
quiPment
O
peratOr
’
s
M
anual
4
Grinder Chamber Assembly and installation
1. If necessary assemble the blade shaft (B) into the worm gear (A). See
Figure 7.
2. Slide the shaft washer (A) onto the worm gear shaft (B). See Figure 6.
3. Slide the shaft washer (A) so that it is seated against the worm gear
assembly (B) as shown. See Figure 5.
4. Slide the worm gear assembly (B) and the shaft washer (A) into the
grinder chamber (C). Slide the worm gear shaft (D) in until it is seated
fully.
5. Slide the knife blade (B) so that the flat ground edges (A) face to the
outside as shown, onto the blade shaft (C). See Figure 8.
C
A
d
B
Figure 8. Knife Blade and Blade shaft Figure
6. Slide the knife blade (B) onto the blade shaft (C) so that it seats
completely over the square (D). See Figure 4.
7. Place the grinder plate (D) onto the blade shaft (A) so that the cutout
(C) slides over the locating pin (B). See Figure 3.
8. If a sausage filler is to be used, place it between the coupling cover
(A) and the grinder chamber (B). See Figure 2.
9. Thread the coupling cover (A) onto the grinder chamber (B) and
tighten securely.
6.
A
B
Figure 6. shaft Washer and Worm gear shaft
7. If desired remove the blade shaft assembly (B) from the worm gear (A). See
Figure 7
A
B
Figure 7. Blade shaft and Worm gear
Thoroughly clean and dry all parts.
t
roubleshooting
Problem
Possible Cause
Course of Action
Grinder stops operating or output is erratic. Grinder is overloaded.
Switch to the “Reverse”position momentarily, turn the unit to the “OFF”
position. Check the following:
Thumb screw too tight; loosen and hand-tighten, do not over-tighten
Discharge plate is blocked; remove and clear
Blade edges are dull; have sharpened or replace
Press the reset button.
Grinder stops operating or output is erratic. Blades are in backwards.
Correct blade direction.
Metal shavings or particles in food product. Blades are in backwards.
Correct blade direction.
Motor humms but does not operate.
Governor out of adjustment. Adjust governor per procedures posted at Vollrathco.com or contact Vollrath
Technical Service.
s
erviCe
and
r
epair
There are no user serviceable parts within this appliance. To avoid serious injury or damage, never attempt to repair the equipment or replace a damaged power
cord yourself. Do not send equipment directly to the Vollrath Company. Please contact the qualified professional repair service listed below.
VOllrATh Technical service • 1-800-628-0832