Vollrath VB25 - Manual (Page 15)

English
Operating instructions
15
7 P
RE
-
WASHING
Do not carry out the rinsing having a very cold cylinder.
- Proceed with rinsing to eliminate the residual ice- cream, using 2 gal. of warm water(30°C), if you soon will produce
other ice- cream;
- Proceed with rinsing to eliminate the residual ice- cream, using 2 gal. of warm water (30°C) and, if the production has
come to an end, proceed with simple washing, accurate washing and disassembling of the parts (see 8 WASHING).
8 W
ASHING
THE FATS CONTAINED IN THE ICE-CREAM MIXTURES ARE IDEAL FOR THE GROWTH OF BACTERIA.
WE RECOMMEND TO WASH AND SANITIZE WITH THE MAXIMUM CARE EVERY PART IN CONTACT WITH
PRODUCT, IN ACCORDANCE WITH CURRENT HEALTH REGULATIONS.
For a long life of the device we suggest not to use solvents, abrasive detergents, or rough sponges, in
particular on the plastic and rubber parts. During the washing operations and in particular during the
rinsing, activate the beating only for the suggested periods. Otherwise you could damage the machine.
DO NOT press the REFRIGERATION Pushbutton [K5] during the washing. Otherwise you would freeze
the water and break the parts of the machine. Do not press the EXTRACTION Pushbutton [K7] because
all the washing solution would come out from the top of the machine. Do not carry out the washing
having a very cold cylinder.
CARRY OUT THE WASHING OF THE DEVICE FOLLOWING THESE PROCEDURES:
1 Simple washing
STEP 1
Prepare a pail with a solution composed by 2 gal. of hot
water (50°C) and 1 oz. of detergent GOLDEN GLO by
SPARTAN CHEMICAL.
STEP 2
Check that the extraction door is closed, open lid, pour
the detergent solution in the tank and close the lid again.
STEP 3
Press the beating pushbutton [K2], this will cause the
detergent solution to be agitated in the tank.
STEP 4
2 minutes later, press the beating pushbutton [K2]
again to stop the agitation, place a pail beneath the
extraction door and clear out the tank.
STEP 5
Rinse only with hot potable water (50°C), repeating steps
2, 3, 4 until the rinse water being drawn from the tank is
clear.
2 Accurate washing and disassembling of the parts
CARRY OUT THESE OPERATIONS ONLY
WITH THE SOCKET'S MAIN BREAKER ON
“0”. THE [Z1] INDICATOR OF THE IGNITION
BUTTON ON THE CONTROL PANEL MUST
BE TURNED OFF.