Vollrath Cayenne 15 Lb Medium Duty Electric Fryers Operator Manual - Manual (Page 5)

C
ountertop
C
ooking
e
quipment
5
ENGLISH
O
peratOr
’
s
M
anual
3. Use a pen or similar narrow tool (A) and press the reset button (B) down.
The button should stay in the down or in the set position. See Figure 4.
A
B
Figure 4. Resetting Switch.
4. Replace the switch cover and secure by screwing clockwise. See
Figure 5.
A
Figure 5. Switch Cover Installation
t
roubleshooting
C
hart
Problem It might be caused by Course of Action
Pilot Light does not come on when
the temperature control is turned up.
Unit is not plugged in. Plug unit in.
Safe Operation Switch in “OFF” position. Check Safe Operation Switch is in “ON” position.
Temperature safety switch is tripped.
Reset temperature safety switch.
Pilot Light malfunction. Replace Pilot Light.
Oil gets too hot.
Oil level low. Turn unit off, allow to cool and add oil to proper level.
Thermostat Control malfunction. Replace Thermostat Control.
Oil does not get hot enough. Thermostat Control malfunction. Replace Thermostat Control.
Oil heats slowly. Low or incorrect voltage to unit.
Verify that voltage rating in unit matches the source voltage. If not
have qualified electrical personnel install proper source voltage.
Oil boils over top when frying.
Too much oil in well. Reduce the amount of oil in well
Too much food in basket. Reduce the amount of food in basket.
Too much water in food. Dry food product or remove ice crystals from food prior to frying.
s
ervice and
r
epair
There are no user serviceable parts within this appliance. To avoid serious injury or damage, never attempt to repair the unit or replace a damaged power cord
yourself. Do not send units directly to the Vollrath Company. Please contact the qualified professional repair service listed below.
VOLLRATH Technical Service • 1-800-628-0832
If unable to reset the temperature safety switch or the switch continues to
trip, contact Vollrath Technical Service.
s
afe
o
peration
s
witCh
This unit is equipped with a safe operation switch. The switch allows power
to the heating element when it is in the correct position. See Figure 6. Safe
operation switch:
1. When the head (C) is in the correct or down position the safe operation
switch (A) is pushed in from pad (B) and the heating element will be
supplied with power.
2. When the head (F) is in the up position or removed from the unit and
pad, (E) switch goes to the “OFF” (D) position and cuts power to the
heating element.
A
B
D
E
C
F
Figure 6. Switch Cover Removal.