Mobile Video HDD HV356T - Manual (Page 44)

Appendix
40
Troubleshooting
Problem Possible Cause Solution
TV screen does not
display normally
◎
Video setting is not correct. ◎
Press and hold then press
MENU until screen displays correctly.
◎
Reboot the TV set and connect the
composite cable instead of the
component cable
No power
(All LEDs are off) The
◎
power plug is not properly
connected.
◎
The unit has not been turned on.
Check the power connection and
◎
plug it again.
◎
Press Power switch to turn it on.
Can’t operate with
the remote control
◎
If this unit can’t be activated by
pressing
button of remote
control, it is probably because
the power is off.
Remote is not point
◎
ing toward
the remote receiver.
The tab of battery
◎
has not been
removed.
◎
Battery is not assembled properly.
Battery
◎
became depleted.
◎
Refer to “No power” section for its
solution.
Point the ◎ remote toward the
receiver when in operation.
Pull out the tab of the battery on
◎
the side of remote control.
◎
Check the battery direction.
◎ Replace the battery.
Some folders are not
listed in “Detail
View”
◎
These folders may be “Hidden”,
“Encrypted”, “Compressed” or
“System Folder”.
◎
Change the attribute of these
folders, or create another folder.
Some files can’t be
played back
◎
These files are compressed by
Windows.
◎
The formats of these files are not
supported.
◎
These files are damaged.
◎
Uncompress them.
◎ Convert these files to some
supported format.
◎ Replace them with undamaged
ones.
The SETUP MENU
appears to be in an
unrecognizable
language. Incorrect
◎
OSD LANGUAGE
setting.
Check the
◎
OSD LANGUAGE
setting in SETUP MENU .
No image Video
◎
cable is not connected.
Incorrect
◎
video setting.
Check video connection
◎
.
◎
Press and hold and then press
MENU repeatedly until the screen
displays correctly.