Installing the print catcher, Installing the print catcher -7 – Kodak 9810 User Manual
Page 11
Advertising
Setting Up the Printer
1-7
5.
Remove the label/wrapper from the ribbon.
6.
Push the right side of the take-up spool into the rear spool holder on the
right.
7.
Place the left side of the take-up spool into the rear spool holder on the
left.
8.
Rotate the take-up spool until it locks into place.
9.
If there is any slack in the ribbon, remove it by turning the take-up spool.
IMPORTANT:
Slack in the ribbon can cause a paper jam when making
prints.
Installing the Print Catcher
The print catcher collects finished prints as they exit the printer.
• Set the print catcher into the printer as shown.
Label/wrapper
Take-up spool
Print catcher
Advertising