Aiphone AXW-AVT - Manual (Page 8)

CONFIGURATION DIAGRAM:
AXW-AVT / AXW-AVR with AFI (American Fibertek) Fiber (MT-/MR-1890), 2 of 2
Pg. 13 Pg. 14
CEU
AUDIO IN
+
-
AUDIO OUT
+
-
CALL IN
+
-
CALL OUT
+
-
RELAY
NO
NO
VIDEO IN
VIDEO OUT
AXW-AVR
To AX-CEU
(Door Input)
Coaxial Video Cable
Normally Open contact for remote device activation
(i.e. video switcher, DVR, etc.)
Composite Video Output
(for CCTV monitor, DVR, etc.)
Configuration Notes (2 of 2):
1. Connect the Call In / Call Out and Audio In / Audio Out connections on the AXW-AVR to the terminal block of the
AFI MR-1890, as shown. For detailed terminal definitions, consult the AFI MR-1890 installation sheet.
2. Connect the AXW-AVR ‘CEU’ connection to an unused Door station input on the AX-CEU and ensure that the
AX-CEU has been programmed to accept a video door station on that input (see Pg. 2).
Application Considerations:
**If the American Fibertek modules relay is to be used for door release, the ‘Call Out’ connection
on the AXW-AVR will not be used. Instead, connect the pins of the MR-1890 to the appropriate
door release output on the AX-CEU. Be sure to short together the ‘Call Out’ terminations on the
AXW-AVT as noted on Pg. 11-12.
Power supply connections to the AFI fiber modules are not shown, and are dictated by the
mounting method chosen (standalone, rack mount, etc.). Contact AFI for available options.
AXW-AVT / AXW-AVR should be mounted as close as possible to their corresponding AFI fiber
modules. Avoid mounting units near high voltage AC devices, or other sources of inductive noise.
Please Note:
Only information pertaining to the connection and operation of the AXW-AVT / AXW-AVR and listed 3
rd party devices interfacing with it are included here. Aiphone is not
responsible for attempts to connect the AXW-AVT / AXW-AVR to untested 3 rd party transmission hardware. Consult the installation manual for the 3 rd party device being utilized
for further information regarding physical mounting, base functionality, power requirements, etc. For the most up-to-date compatibility information, please consult http://
www.aiphone.com or contact Aiphone Technical Support.
For complete AX system installation, wiring, and programming information, please consult the AX Installation Manual (included on CD with AX Central Exchange Unit, or
available at http://www.aiphone.com).
Optic Fiber
(to MT-1890, Pg. 12)
3. The RELAY output on the AXW-AVR
provides a Normally Open dry contact
output whenever the door station
connection is active. This can be used to
activate any device local to the AXW-
AVT (DVR trigger, video switcher
activation, local call indication, etc.).
24VAC
AFI MR-1890
To AFI-specified /supplied
power source
**