Kodak MD1063 - Manual (Page 54)

48 www.kodak.com/go/support
Troubleshooting
Camera/computer communications
LCD screen messages
If... Try one or more of the following
The computer does
not communicate
with the camera. ■ Turn on the camera (see page 3 ).
■ Make sure the battery is fully charged (see page 2 ).
■ Connect the USB cable to camera and computer port (see page 37 ).
■ Install the software (see page 36 ).
■ Disconnect the USB cable. Close all software applications. Re-install
the software (see
page 36 ).
■ Disconnect camera from the computer. Close all software applications,
reconnect camera.
Cannot transfer
pictures.
(The Add New
Hardware Wizard
cannot locate
drivers.) ■ Disconnect the USB cable. (If using camera dock or printer dock,
disconnect cable and remove camera from dock). Close all open
applications. Re-install the software (see
page 36 ).
■ Disconnect the USB cable. Close all software applications. Re-install
the software (see
page 36 ).
■ Reboot the computer.
■ Try another computer.
Slide show stops or
does not run on an
external video
device. ■ Adjust the camera Video Out setting NTSC or PAL ( see page 33 ).
■ Make sure the external device settings are correct. (See the device’s
user’s guide.)
If... Try one or more of the following
No pictures or
videos to display ■ Change image storage location setting ( see page 32 ).