Care and maintenance, Upgrading your software and firmware, The lens – Kodak SPORT C123 User Manual
Page 52
46
www.kodak.com/go/support
Appendix
Care and maintenance
■
If you suspect water has gotten inside the camera, remove the batteries and card.
Allow all components to air-dry for at least 24 hours before using the camera.
■
Blow gently on the lens or LCD to remove dust and dirt. Wipe gently with a soft,
lint-free cloth or an untreated lens-cleaning tissue. Do not use cleaning solutions
unless designed specifically for camera lenses. Do not allow chemicals, such as
suntan lotion, to contact painted surfaces.
■
Service agreements may be available in your country. Contact a dealer of KODAK
Products for more information.
■
For digital camera disposal or recycling information, contact your local authorities.
In the US, go to the Electronics Industry Alliance site at
Kodak at
■
In water, do not use below a depth of 3 meters (9.8 ft).
■
Do not open/close camera doors in water.
■
The camera will not float. Use the strap at all times.
■
If water has entered the camera, remove the card. Allow all components to air-dry
for at least 24 hours before using the camera.
■
If the camera was used in chemically treated water or saltwater, rinse it in fresh
water, then use a soft towel to dry it.
■
Wipe off dirt or sand from the door seals—debris could compromise the seal and
cause a leak when in water.
Upgrading your software and firmware
Download the latest versions of KODAK Software and the camera firmware (the
software that runs on the camera