Kodak M883 User Manual
Page 57
Troubleshooting
www.kodak.com/go/support
51
Picture quality problems
Slide Show does not
run on an external
video device
■
Adjust the camera Video Out setting to NTSC or PAL (
■
Make sure the external device settings are correct. (See the
device’s user’s guide).
Computer does not
communicate with
the camera
■
Make sure the battery is charged and installed correctly (see
■
Turn on the camera.
■
Make sure the USB cable model U-8 is connected to the camera
and the computer (see
). (If using an EasyShare dock,
check all cable connections. Make sure the camera is seated on
the dock.)
■
Make sure EasyShare software is installed (see
).
Status
Solution
Picture is not clear
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■
Clean the lens (see
■
Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
Picture is too dark
■
Reposition the camera for more available light.
■
Use Fill flash (see
) or change your position so light is not
behind the subject.
■
Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
Status
Solution