Kodak LS753 - Manual (Page 47)

Troubleshooting
41
Picture quality problems
Slide Show does not
run on an external
video device ■ Adjust the camera Video Out setting (NTSC or PAL,
page 20 ).
■ Make sure the external device settings are correct
(see the device’s user’s guide).
If... Try one or more of the following
The picture is too dark
or underexposed ■ Use Fill flash ( page 14 ) or change your position so light is
not behind the subject.
■ Move so that the distance between you and the subject is
within the effective flash range (see
page 14 ).
■ To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to
take the picture.
■ Increase Exposure Compensation ( page 16 ) and try again.
The picture is too light ■ Turn flash off ( page 14 ).
■ Move so that the distance between you and the subject is
within the effective flash range (see
page 14 ).
■ To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to
take the picture.
■ Decrease Exposure Compensation ( page 16 )
and try again.
■ Check if you are in Beach or Snow scene mode ( page 10 ).
The picture is not clear ■ To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, gently press the Shutter button completely down
to take the picture.
■ Clean the lens ( page 49 ).
■ Make sure camera is not in Close-up mode if you are
further than 39 in. (100 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod.
If... Try one or more of the following