Kodak DP800 - Manual (Page 2)

Thank you for buying this
Projector, and for choosing "the
brighter way of presenting".
The Projector will display high brightness images with
vivid colours, even under normal light conditions.A s
input for your presentation you can use CD-I, ( a s k
your dealer for the CD-I player),CD RO M ,P h o t o
C D s , Laser Disks, normal VCRs or computers.You can
connect a microphone and have multiple inputs
connected simu l t a n e o u s ly for high impact true
multimedia pre s e n t a t i o n .
Thanks to the unique Graphical User interface, t h e
P rojector offer true plug and play operation fro m
remote contro l , which by the way can also contro l
your computer! For good measure we have eve n
included the Slide Works presentation utility software
with over 50 powerful presentation tools included.
Ask your dealer for information about other
p resentation products and accessories. For add e d
security and convenience try our extended warr a n t y
p ro g r a m .
Before you start
Please take a few minutes to make sure that yo u r
system contains the necessary components for yo u r
p a rticular ap p l i c a t i o n :
P rojector
Lamp module
Serial cable (8 pin)
Super video cable (4 pin)
Composite video cable
Cable for Audio (2RCAm - 2RCA m )
AC cable (4m)
2 Macintosh adap t e r s
9 pin serial adap t e r
A d apter BNC-Composite
I n t e r a c t i ve remote contro l
D i s kette with Macintosh driver software
D i s kette with the Slideworks
p resentation utility software
Batteries for the remote contro l
5 meter (16 ft.) RGB buffer cable
If you want to use the Projector to display video
i n fo r m a t i o n , you will need the cables for S-video or
composite video, all depending on the system you use.
1 Introduction
2 Identifying the different
parts of the Projector
5 4
1
2
3
4
5
6
7
8
9
10
1 1
1 2
1 3
1 4
1 5
This section describes how to
connect the Projector to your PC,
Macintosh, Powerbook or notebook
in order to show computer
graphics.
1 . Identify the parts needed to connect yo u r
computer with the Pro j e c t o r.
2 . Identify the RGB Out connector on the back of
your computer (the one that connects the
monitor to the computer).
3 . M a ke sure that the computer, monitor and the
P rojector are switched off.
4 . Connect the power cable from the Projector to
the wall outlet.
5 . Locate the On/Off switch on the Pro j e c t o r.W i t h
all the connections done and the screws pro p e r ly
f a s t e n e d , the Pro j e c t o r, and computer may be
p owe red up. Switch on the units in the mentioned
s e q u e n c e.
6 . The Projector will now automatically display the
c o m p u t e r ’s image in parallel with the monitor.
7 . If you want to control your computer with the
remote contro l , also connect the serial interface
cable from the RGB buffer cable to the computer
C O M - p o rt , see fig 2 or 3. Connecting the serial
interface cable.
3 Connecting the Projector to your computer
Fig 2.
Connecting to a
desktop computer
or a standard
l a p t o p ,n o t e b o o k
Fig 3.
Connecting to an
Apple Macintosh
desktop computer
or Apple Macintosh
Pow e r b o o k
To Projector
To Projector
0510 CD-Inledning.ENG 12-03-98 16:40 Side 4