Kodak P712 User Manual
Page 38
31
www.kodak.com/go/support
Doing more with your camera
1 Set the Drive mode to the desired option,
2 Press the Shutter button halfway to set the AE/AF.
3 For all settings, except Burst, press the Shutter button completely down to take
the picture.
For Burst settings, press the Shutter button completely down
and hold it. The camera stops taking pictures when you release the Shutter
button, all pictures are taken, or there is no more storage space.
NOTE: To cancel self-timer and shutter delay during countdown, press the Shutter button again.
NOTE: During Quickview, you can delete all pictures in the burst series. To delete selectively, do so in
Review (see
).
Last Burst
Flash forced off.
Camera takes a series of pictures while the Shutter button is
pressed. When the Shutter button is released, only the last 5
pictures are saved (4 pictures in RAW). (Capture an event
when the precise timing is uncertain e.g., a child blowing out
birthday candles.)
Exposure
Bracketing 3
Flash forced off.
Camera takes 3 pictures at intervals of 1/3, 2/3, and 1.0 EV.
Determine the best exposure level for your conditions based
on your evaluation of 3 pictures. Not available in TIFF.
For using exposure compensation with exposure bracketing,
see
.
Exposure
Bracketing 5
Flash forced off.
Camera takes 5 pictures at intervals of 1/3, 2/3, and
1.0 EV. Determine the best exposure level for your conditions
based on your evaluation of 5 pictures (not available in RAW).
For using exposure compensation with exposure bracketing,
see
Time Lapse
Camera takes specified number of pictures (2–99) at specified
intervals (10 seconds–24 hours; 60 seconds–24 hours in TIF
& RAW).
Drive mode
Description