Kodak Z1275 - Manual (Page 58)

52 www.kodak.com/go/support
Troubleshooting
Camera/computer communications
Ready light blinks
amber. ■ Wait. Resume picture taking when the light stops blinking and turns
green.
Ready light blinks
red and camera
turns off. ■ Install new batteries ( see page 1 ) or charge rechargeable batteries.
Ready light glows
steady red. ■ Transfer pictures to the computer ( see page 45 ), delete pictures from
the camera ( see page 15 ), switch image storage locations ( see
page 31 ), or insert a card with available memory ( see page 3 ).
■ Wait. Resume picture taking when the light turns green.
■ Change the image storage location to internal memory ( see page 31 ),
or use a different card.
Ready light is off or
glows steady
green. ■ Camera is operating normally.
If Try one or more of the following
The computer does
not communicate
with the camera. ■ Turn on the camera ( see page 2 ).
■ Install new batteries ( see page 1 ) or charge rechargeable batteries.
■ Connect cable to camera and computer port ( see page 45 ).
■ Install the software ( see page 44 ).
■ Disconnect the USB cable. Close all open applications. Re-install the
software (
see page 44 ).
■ Disconnect camera from the computer. Close all software applications,
reconnect camera.
Cannot transfer
pictures.
(The Add New
Hardware Wizard
cannot locate
drivers.) ■ Disconnect USB cable. (If using camera dock or printer dock,
disconnect cable and remove camera from dock). Close all open
applications. Re-install the software (
see page 44 ).
■ Disconnect the USB cable. Close all open applications. Re-install the
software (
see page 44 ).
If Try one or more of the following