Kodak DC290 - Manual (Page 84)

78
Computer cannot
communicate with the camera. Camera power is off. Turn on the camera.
The Mode dial is not
set to Connect. Set the Mode dial to
Connect.
Conflict with another
device. Refer to the USB.PDF
or Connect.PDF
document supplied
with the camera
software, or your
computer User’s Guide.
Some Advanced
Power Management
utilities on laptops can
turn off ports to save
battery life. See the Power
Management section of
your laptop user’s
guide to disable this
feature.
Camera is not
connected to USB
cable or cable is not
connected to the
computer USB port. Connect USB cable to
camera and computer
USB port. See page 65.
Picture is not clear in Burst
mode. Due to the higher
number of pictures
per burst with
Standard resolution,
pictures are
subsampled before
processing rather than
after processing.
There are less pixels
and slightly lower
sharpness. Use a higher resolution,
which yields fewer
frames per burst.
Camera Problems
Problem Cause Solution