Kodak 805 - Manual (Page 62)

Setting up the Printer
Troubleshooting
Site Specifications
Operating the Printer
Accessories and
Supplies
CONTENTS HELP SEARCH
Introduction
2. Use a lint-free cloth moistened with isopropyl alcohol or distilled water to
clean the print head, and wipe along the heater line four times:
• Wipe the full length of the area (always in one direction).
• Use a clean part of the cloth for each wipe.
• Apply firm, even pressure.
• Wipe only the following areas.
3. Allow the wiped area to dry for about two minutes.
4. Close the top cover and turn on the printer.
5. Make a test print.
NOTE: It may be necessary to repeat Steps 1- 5 several times to remove any
artifacts. If you cannot remove the artifacts, call for service.
Guide bar
Heater line