Kodak MINI M200 - Manual (Page 52)

46 www.kodak.com/go/support
Troubleshooting
Direct printing (PICTBRIDGE enabled printer) problems
Picture quality problems
Status Solution
Cannot print to a
PICTBRIDGE Printer ■ In the Setup menu, change the Computer Connection setting to
Other Application (
see page 39 ).
Status Solution
Picture is not clear ■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ Clean the lens ( see page 50 ).
■ Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject (
see page 36 ).
■ Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
■ Use a larger picture size ( see page 34 ).
■ If you’re manually adjusting the ISO speed, realize that high ISO
setting may cause grainy pictures (
see page 35 ).
Picture is too dark ■ Reposition the camera for more available light.
■ Use Fill flash ( see page 12 ) in Program mode, Backlight in SCN
mode, or change your position so light is not behind the subject.
■ Move so that the distance between you and the subject is within the
effective flash range. (See
Specifications, page 48 .)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Program mode, increase the Exposure Compensation ( see
page 35 ).