Vitek VT-4037 BN - Manual (Page 4)

5.1 Active Speaker System
Carefully read these instructions before installing the system.
SYSTEM COMPONENTS
The following components are included in the 5.1 acoustical system:
1. Subwoofer
2. Five satellite speakers with wires
3. Three audio cables
4. Remote control unit
5. Batteries for remote control unit
6. Operating instructions
DEVICE DESCRIPTION
1. Subwoofer
2. Satellite unit
3. Center unit
4. Signal line
5. Remote
SUBWOOFER REAR PANEL
1. 2.1 Channel audio inputs
2. 5.1 Channel audio inputs
3. Output jacks for front right and left satellite speakers (FR, FL)
4. Output jacks for rear right and left satellite speakers (RR, RL)
5. Output jack for center speaker (CEN)
6. Power switch
7. Power fuse
8. Power cord
9.FM antenna jack
10.AM antenna jack
REMOTE CONTROL UNIT
1. Power on/off button (STANDBY)
2. MUTE button
3. Audio source selection button (INPUT)
4. 3D sound mode button
5. STEREO/MONO signal reception selection button (ST/MN)
6. Volume control buttons for all channels (VOL+/ )
7. Volume control buttons for front left channel (FL+/ )
8. Volume control buttons for front right channel (FR+/ )
9. Volume control buttons for center channel (CEN+/ )
10. Volume control buttons for subwoofer (SUB+/ )
11. Volume control buttons for rear left channel (SL+/ )
12. Volume control buttons for rear right channel (SR+/ )
13. Number entry buttons (0 9)
14. Button for entering number of 10 and higher (10+)
15. Button for programming radio stations into memory (MEMORY)
16.Radio band selection button (AM/FM)
17.Manual tuning buttons (TUNE +/ )
18.Button for automatic tuning of radio stations (SCAN)
ENGLISH
4
CONNECTIONS
4027.qxd 04.10.2005 11:16 Page 4