Lenovo ThinkServer TD340 - Manual (Page 3)

200, 2300, 2400, 2500 Series Adapters Page 3
Step 1. Install the Adapter Hardware
To install the adapter hardware, you need to open the computer and locate the appropriate
bus slot. If necessary, consult your computer system manual for instructions to remove the
computer cover.
To install the adapter hardware:
1. Power off the computer and all attached devices such as monitors, printers, and external
components.
2. Disconnect the power cable.
3. Remove the computer cover and find an appropriate empty bus slot.
4. Pull out the slot cover (if any) by removing the screw or releasing the lever.
5. Install the low-profile bracket (if required).
6. Grasp the adapter by the top edge and seat it firmly into the appropriate slot (see Figure 1).
Figure 1. Server Motherboard and Slots
7. Refasten the adapter’s retaining bracket using the existing screw or lever.
8. Close the computer cover.
9. Plug the Fibre Channel cable into the adapter.
10. Plug in the power cable and turn on the computer.
Step 2. Install the Adapter Driver
To install the adapter driver:
1. Go to the QLogic Downloads and Documentation page:
http://driverdownloads.qlogic.com
2. Under QLogic Products, type the QLogic model name in the search box.
Caution: Keep the adapter in the antistatic bag until installation. The Host Bus Adapter contains parts
that can be damaged by electrostatic discharge (ESD). Before handling the Host Bus
Adapter, use standard methods to discharge static electricity. Place the Host Bus Adapter on
the bag when examining it. Retain the bag for future use.
ADAPTER
RETAINING
BRACKET
LEVER
SLOT COVERS
SYSTEM
CHASSIS
64-BIT PCI-X ® SLOT
X4 PCI EXPRESS ® SLOT
(X8 PHYSICAL SLOT OR
ABOVE REQUIRED FOR
QLE25XX ADAPTERS)
SCREW
HOST BUS ADAPTER
OR