Applying power, Viewing the leds, Applying power viewing the leds – Lenovo ThinkServer TD340 User Manual
Page 14: Figure 2-6 co
LPe16000 Series HBA Installation Manual
P007648-01A Rev. A
2. Installation
Applying Power
13
Once the optical transceivers are installed, insert the optical cable into the LC
connectors on the HBA (see Figure 2-6).
Figure 2-6 Connecting a Fiber Optic Cable
2. After the appropriate cable is connected to the HBA, connect the other end to the FC
device.
After the appropriate fiber optic cable is connected to the HBA, connect the other
end to a FC switch. After the cable is connected to the HBA, you are ready to apply
power to the computer.
Applying Power
To apply power:
1. Verify that the HBA is securely installed in the computer.
2. Verify that the correct media is attached.
3. Plug in and turn on the computer.
4.
Watch the LEDs for Power On Self Test (POST) results.
Viewing the LEDs
You can view green and yellow LEDs through openings in the HBA's mounting
bracket. The green LED indicates firmware operation and the yellow LED indicates