Manual image setup, Manual image setu p – Lenovo LI1920 Wide Monitor User Manual
Page 20
Manual image setup
If automatic image setup does not establish the image that you prefer, perform
manual image setup.
Note: Have your monitor powered on for about 15 minutes, until the monitor warms
up.
The power
indicator is white,
but there is no
image
The video signal cable
is loose or
disconnected from the
system or monitor
Be sure the video cable is
connected with the
system properly
The monitor
brightness and
contrast are at the
lowest setting
Adjust the brightness and
contrast setting on the
OSD menu
page 2-3
One or more of
the pixels appear
discolored
This is a characteristic
of the LCD
technology and is not
an LCD defect
If there are more than five
pixels missing, contact
the Support Center
Appendix A,
Support,” on page
A-1
•
Fuzzy lines
in text or a
blurry
image
•
Horizontal
or vertical
lines
through the
image
•
Image setup has
not been
optimized
•
Your system
Display
Properties setting
have not been
optimized
Adjust the resolution
settings on your system
to match the native
resolution for this
monitor: 1366 x 768 at 60
Hz
page 2-3
Perform automatic image
setup. If automatic image
setup does not help,
perform manual image
setup
When working in the
native resolution, you
may find additional
improvements by
adjusting the Dots Per
Inch (DPI) setting on your
system
See the Advanced
section of your
system’s display
properties
Table 3-2.
Troubleshooting
Problem
Possible cause
Suggested action
Reference
at the bottom of the monitor to open the OSD menu.
1. Press
2. Use or to select and press to access.
or to select Clock and Phase adjustment.
3. Use
• Clock (pixel frequency) adjusts the number of pixels scanned by one
horizontal sweep. If the frequency is not correct, the screen shows vertical
stripes and the picture does not have the correct width.
• Phase adjusts the phase of the pixel clock signal. With a wrong phase
adjustment, the picture has horizontal disturbances in light picture.
4. When the image no longer looks distorted, save the Clock and Phase adjustments.
to leave the OSD menu.
5. Press
Chapter 3. 3-3