Lenovo ThinkStation S20 User Manual
Page 27
To install a new hard disk drive:
1. Remove the computer cover. See “Removing the computer cover” on page 11.
2. Locate one of the empty hard disk drive slots in bay 4. See “Locating internal components” on page 7.
Each empty hard disk drive slot has a spare bracket.
3. Pull the handle to remove a spare bracket.
4. To install the new hard disk drive into the bracket, flex the bracket, and then align pin
1
, pin
2
, pin
3
, and pin
4
on the bracket with the holes in the hard disk drive. Do not touch the circuit board
5
on the bottom of the hard disk drive.
Figure 16. Installing a 3.5-inch hard disk drive into the bracket
Note: If you are installing a 2.5-inch hard disk drive into the bracket, flex the bracket, and then align pin
1
, pin
2
, pin
3
, and pin
4
on the bracket with the holes in the hard disk drive adapter
5
.
Figure 17. Installing a 2.5-inch hard disk drive into the bracket
5. Install the hard disk drive and bracket into the drive bay.
Chapter 3
.
Installing options and replacing hardware
21