Pip/pbp – Lenovo ThinkVision LT2934z 29-inch Panorama AH-IPS WLED Backlit LCD VoIP Professional Monitor User Manual
Page 17
13. Connect one end of source input (like VGA) cable to the monitor and the other end to the
computer. Connect one end of other source input (like DP) cable to the monitor and the
other end to the computer. Use the OSD controls to enter the PIP/PBP mode.
PIP/PBP
Note: The source input should follow below table.
PIP/PBP Input Pairing Limitation
HDMI
MHL
DVI
VGA
DP
HDMI
No
No
No
Yes
Yes
MHL
No
No
No
Yes
Yes
DVI
No
No
No
Yes
Yes
VGA
Yes
Yes
Yes
No
Yes
DP
Yes
Yes
Yes
Yes
No
14. Insert the power cord into the monitor,
and then plug the monitor power cord and the
computer
cord into grounded electrical outlets.
Note: A certified power supply cord has to be used with this equipment. The relevant
national installation and or equipment regulations shall be considered. A certified power
supply cord not lighter than ordinary polyvinyl chloride flexible cord according to
IEC 60227 (designation H05VV-F 3G 0.75mm
2
or H05VVH2-F2 3G 0.75mm
2
) shall be
used. Alternative a flexible cord be of synthetic rubber according to IEC 60245
(designation H05RR-F 3G 0.75c) shall be used.
Chapter 1.
1-13