American Power Conversion AmpMeter PDU - Manual (Page 32)

3. Operations
Displaying FTP configuration information
The Show FTP command displays all FTP configuration information.
• FTP Host IP address
• FTP Host username and password
• Firmware filepath and filename
To display FTP configuration information:
At the AmpMeter PDU: prompt, type show ftp and press Enter .
Example
The following command displays the FTP configuration information:
AmpMeter PDU: show ftp<Enter>
FTP Configuration
Host IP Address: 12.34.56.99
Username: guest
Password: OpenSesame
Directory: ftp://AmpMeter PDU
Filename: snb_s53a.bin
SNTP Administration
AmpMeter PDU supports the use of a network time service to provide a synchronized time reference.
Setting the SNTP server address
The Set SNTP command is used to set the primary and secondary SNTP server addresses.
To set the SNTP server address:
At the AmpMeter PDU: prompt, type set sntp , followed by primary or secondary , and the SNTP server IP
address. Press Enter .
Example
The following command set the primary SNTP server address to 204.152.184.72:
AmpMeter PDU: set sntp primary 204.152.184.72<Enter>
Displaying SNTP configuration information
The Show SNTP command displays all SNTP configuration information.
To display SNTP configuration information
At the AmpMeter PDU: prompt, type show sntp and press Enter .
Example
The following command displays the SNTP configuration information:
AmpMeter PDU: show sntp <Enter>
SNTP Date/Time (GMT): 2003-02-21 21:32:48
SNTP Primary IP Address: 204.152.184.72
SNTP Secondary IP Address: 0.0.0.0
Page 32 - 301-0399-3 Rev A.