Lenovo LS2013 Wide Flat Panel Monitor - Manual (Page 18)

Caring for your monitor
Be sure to turn off the power before you perform any maintenance on the monitor.
Do not:
• Apply water or liquid directly to your monitor.
• Use solvents or abrasives.
• Use flammable cleaning materials to clean your monitor or any other electrical
equipment.
• Touch the screen area of your monitor with sharp or abrasive items. This type of
contact may cause permanent damage to your screen.
• Use any cleaner which contains an anti-static solution or similar additives. This
may harm the coating of the screen area.
Do:
• Lightly dampen a soft cloth with water and use this to gently wipe the covers and
the screen.
• Remove grease or finger marks with a damp cloth and a little mild detergent.
Preparing the monitor for wall-mounting
WARNING : To reduce the risk of personal injury or of damage to the equipment,
check that the wall-mounting fixture is adequately installed and secured before
attaching the monitor. Refer to the instructions supplied with the wall-mounting
fixture and check that it is capable of supporting the monitor.
1.
Disconnect the power cable and any other cables from the monitor.
2.
Place the monitor face down on a flat, protected surface.
3.
Remove the monitor base from stand.
4.
Remove the monitor stand cover by pushing the top surface of the cover.
5.
Remove the three screws in the monitor stand. Lift the monitor stand off the monitor.
6.
Four threaded holes are exposed. These holes are for screws to attach the
swing arm or other mounting fixture to the back of the monitor.
7. Follow the instructions included with the mounting fixture to ensure
that the monitor is safely attached.
8. Attach a swing arm or other mounting fixture.
NOTE: For use only with UL(expand UL) Listed Wall Mount Bracket with
minimum weight/load bearing capacity of 3.5 kg.
Chapter 2.
2-9